Welcome, Guest. Please login or register.

Username: Password:
Pages: 1 2 [3]

Author Topic: AstroEQ Basic Hand Controllers  (Read 18874 times)

johnyjf

  • Jr. Member
  • **
  • Posts: 8
    • View Profile
Re: AstroEQ Basic Hand Controllers
« Reply #30 on: November 13, 2019, 10:26:22 »
Hi Tom,
Where can you buy the Hand Controlleryou show?  It looks very neat.A quick look on eBay showed many thousands of car key fobe options but I couldn't find one of there.
John
Logged
Regards,

Johnyjf

tombkk

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: AstroEQ Basic Hand Controllers
« Reply #31 on: August 06, 2020, 03:28:05 »
I 3D-printed hand-controller enclosure for the V4.6 PCB from ABS plastic (see 1:57 in the clip). I use a ATTiny85 Arduino board and a five-position switch for mode and speed selection (long-push = cycle through ST-4 - 2x - GOTO mode, click LEFT - RIGHT - UP - DOWN = R.A.- - R.A.+ - DEC+ - DEC-).  There is a red-green LED indicator to indicate the mode (green = ST-4, orange = 2x, red = GOTO). See 2:05 for details.

I also 3D-printed enclosure for 0.9° NEMA-17 DEC (1:28) & R.A. (1:38) motors.

https://www.youtube.com/watch?v=wOYMoVUSzXo
« Last Edit: August 06, 2020, 03:32:16 by tombkk »
Logged
Pages: 1 2 [3]
« previous next »