Welcome, Guest. Please login or register.

Username: Password:

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - johnyjf

Pages: [1]
1
DIY AstroEQ / "Write Failed connec tion unavailable"
« on: May 22, 2020, 15:40:34 »
I have been trying to get my AstroEQ board configured to run with an EQ5 (will actually be run with a GPE but that isn'r relative to this problem) .  When I try to run the config utility all works well until the last when the message above appears and it takes me back a stage.  The power light is on full time, the usb light is pulsing and the status light flashes as the utility tries to upload and write the config but the result is as said.  Any ideas please.

2
DIY AstroEQ / Cannot Update Controller!
« on: December 10, 2019, 15:24:45 »
Just built me controller (V4.6) using all Farnell parts aprt from the PCB and Micro-controllers which were purchased pre-programmed.  when I fired up the Astro EQ config utility it informed I had out of date firmware so I used the utility to update it.  The update attempt failed and I get a message stating "Programmer not responding" and "Not in sync".  I have attached a picture of my controller to aid in diagnosis, any help would be appreciated.

Pages: [1]